Super Smoky Beef Jerky Recipe

A great smoky flavor is awesome with beef but sometimes you don't have the time to smoke your meat first. Our Super Smoky Beef Jerky recipe uses paprika, chipotle powder, and liquid smoke to infuse the meat with a smoky taste.

You can increase or reduce the amount of chipotle powder to your taste.

Super Smoky Beef Jerky Recipe


Super Smoky Beef Jerky Ingredients


For the Super Smoky Rub

2 tablespoons paprika
2 tablespoons garlic powder
2 tablespoons ground cumin
2 tablespoons ground coriander
1 teaspoon cinnamon
1 teaspoon dried oregano
1 tablespoon chipotle powder
2 tablespoons salt

For the Super Smoky Beef Jerky

3 pounds of meat (about 1360 grams), preferably eye of round or similar lean cut
3 tablespoons liquid smoke
3 tablespoons Worcester sauce
1/4 to 1/2 cup super smoky rub

Super Smoky Beef Jerky Instructions


For the Super Smoky Rub

Combine all the spices in a small bowl and mix well.

For the Super Smoky Beef Jerky

Trim all the fat, gristle, and silver skin from the beef. Slice the beef into thin strips against the grain. Set the strips down in a large container like a bowl or a flat tray.

Sprinkle the liquid smoke and Worcester sauce over the beef strips. Coat the beef strips with the spices, mixing it all together well to be sure they are all coated.

Place them in a plastic bag or bowl and refrigerate for several hours or over night.

Making Super Smoky Beef Jerky in the Oven

Preheat the oven to 160°F / 71°C, or the lowest setting it will go.

Remove the beef slices from the container and layer the strips in a single layer on a baking tray, or drying rack on top of a cookie sheet. Make sure the beef strips don't overlap and have a little space between them to enable good air circulation.

Arrange the oven shelves leaving at least 4 inches of space from the top and bottom sources of heat to achieve even heating. Place the strips in the oven to start dehydrating them.

Making Super Smoky Beef Jerky in a Dehydrator

Preheat your dehydrator to at least 141°F / 60.5°C and up to 165°F / 74°C.

Place the strips in a single layer on the dehydrator trays. Be sure to leave some space between the jerky strips for sufficient air flow. If you are not using wire or mesh trays you may need to turn the beef jerky over once in the middle of the drying process.

Dry the beef jerky for 6 to 10 hours. If thicker strips of meat are used it may take longer.

Finishing the Super Smoky Beef Jerky

To test the beef jerky remove a strip or two from the oven racks or dehydrator trays with clean kitchen tongs. Dried beef jerky strips should be chewy but still tender. When bent, it should be flexible enough not to break but it should crack instead.

Once the super smoky beef jerky is sufficiently dry, remove it from the dehydrator and let it cool for 30 to 60 minutes. If there is any oil or moisture on the beef jerky use paper towels to blot it dry.

Put the super smoky beef jerky in tightly sealed containers then refrigerate or freeze. They will last in the refrigerator for a month or two and in the freezer for several months.

placeholder image

Cookie Consent

This website uses cookies or similar technologies, to enhance your browsing experience and provide personalized recommendations. By continuing to use our website, you agree to our Privacy Policy